Product code: 101600
Using a specialist silicone material to capture each corner of the
phone and a welded military grade Rivertex spine – the phone
harness is a perfect combination of flexability and strength.
The flexibility of the silicone means that this case will work for
all smartphones, any size – the Rivertex spine limits the vertical
stretch meaning that the silicone ends will not come off the
phone under stretch.
Most silicone phone cases have an attachment point at the
bottom of the case – this means that under stress or during a
drop the case elongates and the phone can come out of the case.
The design engineers at NLG recognised this as a major issue
and have overcome this by having a central D Ring attachment
point. This clever design means that in a drop scenario that case
pulls all four corners towards the center of the phone – the case
actually tightens on itself in a drop scenario.
In addition to routine checks prior to each use, all equipment should undergo regular detailed inspection, conducted and recorded by a competent person using the NLG Inspection Checklist. If any part is worn or shows signs of degradation, immediately retire from service. In the event of a drop, quarantine
The Phone Harness™ can fit most phones ranging from sizes 130x60mm – right up to 200x110mm
The Phone Harness™ has been third party tested (ANSI-121:2018) to a strength of up to 300g.
The Phone Harness™ uses a high-strength, Rivertex® central section with high-frequency welded seams to ensure ultimate stability and durability when installed on your device.
The Phone Harness™ uses custom-moulded silicone components to snugly fit onto most phones. The clear silicone ensures that there is no colour blur at the edge of the camera. The design also ensures that the harness does not loosen during a drop scenario.
The Phone Harness™ is to be used with the 101371 NLG Mini Coil Tool Lanyard and any NLG appropriately load rated anchor point.